Service Manual

GreensPro 1200 Page 5 - 31 Chassis
Chassis
Installation
(Figures 67 through 71.)
Figure 67
CAUTION
1. Lift drive roller assembly (4) into place, and attach
bearing assembly (5) to frame using two cap screws
(1), two lock nuts (2), and four flat washers (3).
Figure 68
2. Attach bearing assembly (7) at other end of drive
roller assembly (4) to frame using two cap screws (8),
two lock nuts (9), and four flat washers (10).
NOTE: After installation of drive roller, make sure that it
is centered between frame brackets. If necessary,
loosen set screws on bearing collars and move roller
so that it is centered in frame.
Figure 69
3. Apply anti-seize lubricant to transmission output
shaft. Install 8-tooth sprockets (11) on transmission
output shaft. Make sure that sprockets are aligned and
flanges (13) are facing each other.
4. Install retaining ring (12).
Figure 70
5. Install drive chain (17) and sprocket (14).
To prevent personal injury, make sure that drive
roller assembly is supported as it is installed
into the machine. Drive roller assembly weighs
approximately 66 pounds (30 kg).
4
321
5
6
8 9 10
4
7
11
13
12
13
14
15
16
17