Service Manual

Chassis Page 5 - 32 GreensPro 1200

6. Apply a thin film of oil to outside diameter of hub

(15) before installation.

7. Install key (16) and hub (15), aligning the three

holes in the hub and sprocket.

8. Install and tighten two set screws (13).

Figure 71

9. Install drive chain tension assembly (23) using cap

screw (24), spacer (20), flat washer (25), two flat

washers (18), and lock nut (19).

10. Install flat washer (22) and nut (21).

NOTE: If additional chain tension adjustment is

needed, both nuts on tension rod can be installed on

outside of frame bracket.

11. Adjust drive chain tension and lubricate chain.

(Refer to Operator’s Manual.) Dri-Slide

Multi-Purpose

Lubricant (or equivalent) is recommended for

lubrication.

After drive chain adjustment, the drive chain should

have 0.200 in. to 0.300 in. (5 to 8 mm) deflection at

mid-span between the sprockets.

12. Install and secure transmission cover (see

Transmission Cover in this section).

13. Lower machine to the ground.