Service Manual

GreensPro 1200 Page 5 - 35 Chassis
Chassis
Lift Arm Assembly
Removal
(Figure 74.)
Figure 74
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from spark plug.
2. Remove transport wheel hubs. (See Transport
Wheel Hub in this section.)
3. Release latch, lower the transport axle, and support
the tow bar.
1. Axle clamp bolt (6 used) 7. Flat washer 13. Lifting bar 19. Gas spring 25. Nut
2. Lock washer (6 used) 8. Nut 14. Cap screw 20. Nut 26. Lifting axle
3. Flat washer (6 used) 9. Lock washer 15. Flat washer 21. Flat washer (2 used) 27. Lifting bar
4. Axle clamp plate (3 used) 10. Cap screw 16. Lock washer 22. Flat washer 28. Bushing
5. Axle clamp (3 pairs used) 11. Cap screw 17. Lock nut (2 used) 23. Lock nut 29. Flat washer
6. Lock nut 12. Bushing 18. Flat washer 24. Cap screw 30. Cap screw
27
18
15
14
17
19
13
12
5
11
16
25
26
20
21
24
23
22
21
17
6
7
8
9
10
5
4
3
2
4
4
3
2
3
2
28
29
30
1
1
1