Service Manual

GreensPro 1200 Page 5 - 39 Chassis

Chassis

Tow Bar Assembly

Removal

(Figure 76.)

Figure 76

1. Park machine on a clean, level surface with the

transport wheels in the raised and locked position.

Make sure engine is OFF. Remove spark plug wire

from spark plug.

2. Raise machine (transport wheels down and locked).

Chock the transport wheels and support front and rear

of the machine to prevent it from shifting.

3. Support the tow bar (12).

4. Remove nut (11), flat washer (10), cap screw (5),

flat washer (6), and bushing (8), and disconnect lifting

bar (3) from tow bar (12).

5. Remove nut (11), flat washer (10), cap screw (19),

flat washer (18), and bushing (16), and disconnect

lifting bar (21) from tow bar (12).

6. Lower the tow bar (12) to the ground.

1. Ball joint 6. Flat washer 11. Nut (2 used) 16. Bushing 21. Lifting bar

2. Nut 7. Ball joint 12. Tow bar 17. Ball joint (LH threads) 22. Nut

3. Lifting bar 8. Bushing 13. Axle clamp plate (8 used) 18. Flat washer 23. Ball joint

4. Nut 9. Axle clamp (4 pairs used) 14. Heavy flat washer (16 used) 19. Cap screw 24. Nut (8 used)

5. Cap screw 10. Flat washer (2 used) 15. Tow bar clamp screw (8 used) 20. Nut (LH threads)