Installation Instructions

FormNo.3376-381RevB

RollerScraperKit

GreensPro

™

1200GreensRoller

ModelNo.44911

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Long-scraperwire2

Short-scraperwire

Longbushing4

Shortbushing

Washer4

Springwasher

Locknut4

Scraper-wiretensioningtool

Installtherollerscraper.

InstallingtheRollerScraperwiththeTensioningTool

1.Insertthelong-scraperwireandtheshortbushingintotheinnersideofaroller-headframe(Figure1).

2.Insertthelong-scraperwireintotheothersideoftheroller-headframe(Figure1).

G021900

Figure1

1.Shortbushing4.Scraper-wiretensioningtool7.Springwasher

2.Long-scraperwire5.Longbushing8.Locknut

3.Roller-headframe

6.Washer

9.Short-scraperwire

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUK.

AllRightsReserved

*3376-381*B

PAGE 1
Form No. 3376-381 Rev B Roller Scraper Kit GreensPro™ 1200 Greens Roller Model No. 44911 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Long-scraper wire Short-scraper wire Long bushing Short bushing Washer Spring washer Locknut Scraper-wire tensioning tool 2 2 4 4 4 4 4 1 Install the roller scraper. Installing the Roller Scraper with the Tensioning Tool 1.
PAGE 2
3. Insert the long bushing, and align the washer, spring washer, and locknut (Figure 1). 4. Using the scraper-wire tensioning tool to hold the long-scraper wire inside the roller-head frame, tighten the nut until the wire is tight (Figure 1). Note: If you do not have the scraper-wire tensioning tool, you can use a long-nose pliers instead. 5. Repeat steps 1 through 4 for the short-scraper wire. 6. Repeat steps 1 through 5 for the other roller-head frame.