Operator's Manual

3.Installthetransportwheelsontothewheelhubswith
thelugnuts.Hand-tightenthelugnuts.
Note:Thelugnutswillbetorquedatthecompletion
ofstep2.
4.Adjustthetirepressureto69kPa(10psi).
2
InstallingtheHitchAssembly
Partsneededforthisprocedure:
1Hitchassembly
1
Bolt(M10x100mm)
2
Washer(M10)
1
Nut(M10)
1
Bolt(M12x100mm)
2
Washer(M12)
1
Nut(M12)
2
Spacerwasher(whenapplicable)
Procedure
1.Securethehitchtothehitchpivotbracketwiththe
appropriatehardware;refertoFigure4.
•Inthefrontholes,useabolt(M10x100mm),2
washers(M10),andanut(M10).
•Intherearholes,useabolt(M12x100mm),2
washers(M12),andanut(M12).
•Ifyourmachinehasa3rdwasherincludedwith
eachbolt,usethosewashersasspacersbetween
thehitchandtheinsideofthehitchpivotbracket
(Figure5).
Note:Usetheholesinthehitchpivotbracketto
matchthehitchheightofthetowvehiclehitch.
Figure4
1.Hitch
5.Washer(M12),2
2.Hitchpivotbracket
6.Bolt(M12)
3.Washer(M10),27.Nut(M12)
4.Bolt(M10)8.Nut(M10)
Figure5
1.Spacerwashers
2.Tightenthefrontboltsto73N-m(54ft-lb)andthe
backboltsto171N-m(126ft-lb).
12