Operator's Manual

1
InstallingtheTransport
Wheels
Partsneededforthisprocedure:
2Transportwheel
Procedure
1.Removethelugnutssecuringthewheelhubstothe
shippingbrackets(Figure3).Also,removethenuts
threadedontothestudofeachwheelhub.
Figure3
1.Lugnut
2.Shippingbracket
2.Carefullyremovetheshippingbracketsfromthecrates.
3.Installthetransportwheelsontothewheelhubswith
thelugnuts.Hand-tightenthelugnuts.
Note:Thelugnutswillbetorquedatthecompletion
ofstep2.
4.Adjustthetirepressureto103kPa(15psi).
2
InstallingtheHitchAssembly
Partsneededforthisprocedure:
1Lockbracket
4
Bolt(M10x30mm)
4
Lockwasher(M10)
6
Washer(M10)
4
Nut(M10)
1Hitchassembly
1
Bolt(M10x100mm)
1
Locknut(M10)
1
Bolt(M12x100mm)
2
Washer(M12)
1
Locknut(M12)
2
Spacerwasher(whenapplicable)
Procedure
1.Installthelockbrackettotheframeofthemachineas
showninFigure4.
Note:Torquethenutsto52N∙m(38ft-lb).
Figure4
1.Bolt—M10x30mm(4)4.Nut—M10(4)
2.Lockwasher—M10(4)
5.Lockbracket
3.Washer—M10(4)
2.Securethehitchtothehitchpivotbracketwiththe
appropriatehardware;refertoFigure5.
•Inthefrontholes,useabolt(M10x100mm),2
washers(M10),andalocknut(M10).
11