Installation Instructions

FormNo.3380-737RevA

LEDLightKit

GreensPro

™

1240GreensRoller

ModelNo.44923

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Lightmountingbracket(right)

Lightmountingbracket(left)

LEDlight2

Hex-headbolt(M6x20mm)

Locknut(M6)

Washer(1/4x7/8inch)

Washer(M6x20mm)

InstalltheLEDlights.

Switch

Wiringharness1

Cabletie

Installtheswitchandthewiringharness.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUK

AllRightsReserved

*3380-737*A

PAGE 1
Form No. 3380-737 Rev A LED Light Kit GreensPro™ 1240 Greens Roller Model No. 44923 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Loose Parts Use the chart below to verify that all parts have been shipped.
PAGE 2
Installing the LED Lights 1. Align the left light mounting bracket with the hole in the rear left corner of the seat pan (Figure 1). Note: The bracket should be nearly parallel with the ground. If it is not, try the other bracket; refer to Figure 2. 1 7 6 2 3 5 4 G025238 Figure 2 2. Secure the bracket to the seat pan with a hex-head bolt (M6 x 20 mm), a large washer (1/4 x 7/8 inch), a small washer (M6 x 12 mm), and a locknut (M6). G025237 3.
PAGE 3
Installing the Switch and the Wiring Harness 1 1. Remove and discard the hole plug that is installed in the hole near the hour meter in the side of the seat pan. 1 2 2 2 G025245 Figure 6 Underside shown G025239 Figure 3 1. Light switch 1. Light kit wiring harness 2. Cable ties 2. Hole plug 6. Connect the remaining connectors to the lights. 2. Insert the switch into the hole (Figure 3). 7. Secure the wiring harness with the cable ties in the locations shown in Figure 6. 3.
PAGE 4