Operator's Manual

Setup Instructions Page 21
How to Prepare the Electrical
Connections on EH Model
There are three available electrical connections to be
made with your MH-400 EH:
• Electrical power from your tow-vehicle
• Control Pendant
• Electric Brakes (if equipped)
1. Install the Tow-Vehicle electrical connection kit to
the tow-vehicle’s battery, being careful to route the
wires safely to avoid heat or abrasion damage.
Connect the MH-400 EH electrical harness into the
tow-vehicle’s plug.
2. Install the control pendant assembly into the
appropriate mount (swing arm or tow vehicle).
Figure 11: Control Pendant on Swing Arm
Figure 12: Control Pendant on Tow Vehicle Mount
3. Plug the control pendant cord into the MH-400 EH
pendant connector located at the end of the swing
arm or rear of the tow vehicle.
Note –When not using the MH-400 EH, always remove
the control pendant assembly and store indoors.