Operator's Manual

Page 32 Operating Instructions
How to Operate the Cross Conveyor
How to Extend and Retract the Cross Conveyor
Always operate the cross conveyor separately from the
main conveyor belt.
CAUTION: Always return the cross
conveyor to the center position when
traveling, otherwise the cross conveyor
can hit people or objects, and can also
be damaged (Figure 21).
1. Remove the safety pins from both option attachment
clamps on the swivel kit.
2. Loosen the option attachment clamp brackets.
3. Slide the conveyor to the center or side.
4. Re-tighten the clamp brackets.
5. Re-install the safety pins.
6. On SH models adjust the speed of the cross conveyor
with the hydraulic lever on the right. On EH models
adjust the speed of the cross conveyer with the
control pendant.
Figure 21: Cross conveyor positions without swivel kit
A. Extended position when conveying
B. Centered position when traveling
C. Material outlet (motor end)
Note – Always lower the hopper before adjusting the
cross conveyor. Otherwise, the cross conveyor will rest at
an angle.
How to Spread Material from the Cross Conveyor
1. Turn off the tow vehicle.
2. On SH models using the control levers, turn on the
option and the conveyor belt (unload position).
3. Open the adjustable section of the rear gate to allow
for the desired flow rate. You may have to
experiment until you get the desired flow and spread
depth. Other variables include ground speed and the
type of material.
4. Turn on the tow vehicle hydraulics.
5. On EH models operate the option and the conveyer
belt with the control pendant.
6. On SH models turn off the tow vehicle hydraulics to
stop material movement, or turn off the on/off
pendant switch.
Note – For SH models the on/off pendant switch stops the
MH-400 conveyor belt, not the cross conveyor.
7. When finishing using the cross conveyor, always
return it to the center position.