Setup Instructions

Setup Instructions Page 5
The tow vehicle hydraulics are required to run the on/off
pendant switch on SH Models.
25. Take the universal power feed wire (3.9 m [13 ft]
length) and attach the alligator clips to the tow
vehicle’s battery.
26. Run the wire to the back of the tow vehicle and
connect it to the wire located with the pressure and
return hydraulic hoses.
27. Test the operation of the MH-400. Ensure that there
are no hydraulic leaks. Make any adjustments
required.
28. Attach and test each of the options to ensure proper
operation (refer to the Operator’s Manual).
29. If MH-400 is equipped with a brake kit, please refer
to the setup manual for the set up procedure.
How to Set Up the Option Caddy (1)
The option caddy is designed for one person to easily lift,
transport, and mount the Twin Spinner, swivel kit, or
cross conveyor onto the MH-400.
1. Remove all wooden shipping blocks and banding
before proceeding with installation.
2. Install the left and right side legs into the slots using
the supplied 12.5 x 87.5 mm (½ x 3½ in) bolts,
washers (top and bottom) and nylon locking nuts
(Figure 12).
Figure 12: Install legs on option caddy
3. Remove the left and right lift fork stop plates
(Figure 13).
Figure 13: Remove lift fork stop plates
4. Install both forks onto the slide plate (Figure 14).
Figure 14: Install forks onto the slide plate
5. Re-install the lift fork stop plates using:
• 7.8 x 31.25 mm (5/16 x 1¼ in) GR8 bolts
• 7.8 mm (5/16 in) GR8 flat washers
• 7.8 mm (5/16 in) GR8 nylon locking nuts
6. Check that the tire pressure on all tires is
206 kPa (30 psi) maximum.