Setup Instructions

Page 8 Setup Instructions
How to Set Up the Cross Conveyor
1. Install the front deflector shield, with the rubber
hanging down, to the inside rail of the cross
conveyor (on the motor end), using two 6.35 x
25 mm (¼ x 1 in) bolts and nylon locking nuts.
These will be found loosely in place where the
deflector shield is to be mounted. Place the flat
washers between the side rail of the cross conveyor
and the front deflector shield bar. Tighten only
enough so that the deflector shield can still pivot.
2. Unbolt the guard and the mounting bracket from the
hydraulic motor and keep all the bolts and washers to
reinstall.
3. Slide the mounting bracket into position on the cross
conveyor so that the side rail fits through the cut outs
on the bracket. Place the shaft from the motor
through the hole on the mounting bracket and into
the coupler. Reinstall the 9.53 x 25 mm (3/8 x 1 in)
bolts, lock washers and flat washers through the
mounting bracket and into the hydraulic motor as
they were shipped, keeping the hydraulic ports and
hoses horizontal to the cross conveyor (Figure 20).
4. Tighten the set screws on the coupler to the hydraulic
motor shaft.
Figure 20: Install bolts and tighten set screws
5. Reinstall the guard onto the motor bracket using the
7.94 x 15.88 mm (5/16 x 5/8 in) bolt, lock washer
and flat washer supplied.
6. Assemble the two storage stands (the base and cross
members) using the 6.35 x 44.45 mm (1/4 x 1 ¾ in)
bolts, flat washers and nylon locking nuts (Figure
21).
7. Install the conveyor handles to the unit. Attach the
handles below the side rails, using the 6.35 x 19mm
(¼ x ¾ in) bolts, flat washers and nylon locking nuts
(Figure 22).
Figure 21: Cross conveyor storage stands
Figure 22: Cross conveyer handles
How to Set Up the Swivel Kit
8. Mount the rubber scraper on top of the swivel kit.
Ensure the vertical portion of the rubber scraper is on
the same side as the hopper opening (same
orientation as the twin spinner rubber scraper, see
Figure 15).
9. Mount the retainer bar across the rubber scraper, and
tighten the five 7.8 mm (5/16 in) bolts with the nylon
locking nuts.