Setup Instructions

Setup Instructions Page 11
their total length. You may have to move the power
pack forward or cut the PTO shaft.
9. Install the MH-400 pressure and return hoses to the
PTO. The female quick coupler closest to the control
lever is the pressure port. The return hose has an
inline one way check valve.
10. Fill the hydraulic PTO tank with a recommended
hydraulic fluid (see the hydraulic fluid chart in the
Operator’s Manual).
11. Test the PTO power pack to ensure proper operation.
12. After testing, top up the PTO hydraulic fluid if
necessary.
WARNING: Do not operate the hydraulic
power pack when making a sharp turn.
Always disengage the power pack first.
How to Install the On/Off Pendant
Switch On SH Models
1. Remove the hydraulic valve cover and hydraulic
guard from the fender and the fender guard.
(Figure 26) With a pair of side cutters, ensure that
the tie straps are cut off from the lift cylinder control.
Figure 26: Remove hydraulic valve cover
and hydraulic guard
2. Remove the fender guard from the fender by
removing the three carriage bolts, which can be
accessed in the wheel well.
3. Lay the fender guard on the bench with the angle
facing up.
4. Measure, mark, center punch, and drill two holes
(Figure 42 inset: L.H. Fender Panel).
5. Attach the solenoid to the fender panel with three
6.25 mm (¼ in) washers between the fender panel
and the solenoid (to act as spacers).
Note – Ensure that the black solenoids do not touch the
fender. Also ensure that the rubber clamp holding the
wiring is attached to the left mounting bolt.
6. Re-install the fender guard onto the fender, with the
hydraulic valve bank attached, using the three
original carriage bolts and nylon locking nuts
(Figure 27).
Figure 27: Re-install fender guard with hydraulic
valve bank
Lift cylinder
control