Setup Instructions

Page 12 Setup Instructions
7. Remove both hydraulic line clamps and hardware
from the fender (Figure 28).
Figure 28: Remove hydraulic line clamps and
hardware
8. Remove and discard the hydraulic hose that is
farthest away from the valve control lever on the first
hydraulic control valve (Figure 29, top arrow).
Figure 29: Remove and discard far hydraulic hose
9. Remove the hydraulic hose closest to the valve lever
and move out of the way (Figure 27, bottom arrow).
This hose will be re-attached later.
10. Remove the two hydraulic fittings (90-degree) from
the top of the hydraulic control valve (Figure 30).
Figure30: Remove hydraulic fittings
Note – When installing hydraulic hoses or fittings, use
Loctite #545 (sealant) and Loctite #7471 (primer).
11. Install the connector fitting (½ mjic – ½ mpt) to the
inside valve port (Figure 31).
Figure 31 Install connector fitting to inside valve port