Setup Instructions

Setup Instructions Page 13
12. Install the tee fitting (½ mjic – ½ mjic – ½ mpt) to
the outer valve port. Ensure that the angle of the tee
fitting is the same as the angle of the 90-degree
fittings that you removed (Figure 32).
Figure 32: Install tee fitting to outer valve port
13. Re-install the hose that was disconnected in Step 9 to
the side of the tee fitting (Figure 33).
Figure 33: Re-install hose to side of tee fitting
14. Install the Item 8 hose to the hydraulic valve bank
port #4 (Figure 44).
15. Install the opposite end of the Item 8 hose to the
open hard line (Figure 34).
Figure 34: Install end of Item 8 hose to open hard line
16. Position both hoses side by side and re-install the
hydraulic line clamps on the side of the MH-400
(Figure 35). You may need to loosen the hose ends to
properly fit the clamps.
Figure 35: Re-install hydraulic line clamps
17. Install the Item 6 hose and the 90-degree fitting end
to point B of the hydraulic control valve (Figure 36,
right arrow, and Figure 44).