Setup Instructions

Setup Instructions Page 15
27. On one end, cut a hole through the sheath 18.75 mm
(¾ in) away from the end (ensure that you cut
through both sides). This will be the front end of the
sheathing.
28. On the opposite end, cut a hole through the sheath
37.5 mm (1½ in) away from the end. This will be the
rear end of the sheathing.
29. On the front end, take five or six large paper clips
and slide them over the end. These will help keep the
fold in place when you slide through the hydraulic
hose and wiring (Figure 43).
30. Slide the grey solenoid wiring harness and both
pressure and return hoses through the rear end of the
black protective hose sheath.
31. Slide the sheath up to the point where the hydraulic
hoses are attached to the front of the MH-400 with
the hydraulic line clamps (Figure 40).
32. Using the supplied 6.25 x 75 mm (¼ x 3 in) bolt,
attach the hydraulic hoses and the wiring harness to
the existing hydraulic line clamp mounting point. Do
not crush the wiring harness (Figure 40).
Figure 40: Slide sheath to hydraulic hose attachment;
attach hydraulic hoses
33. Pull both the hoses and the grey solenoid wiring
harness straight. Ensure that the hose sheath is not
bunching.
34. Install the 9.4 x 68.75 mm (⅜ x 2¾ in) bolt with two
washers, one nylon locking nut, and two hydraulic
line clamps at the hole you previously cut into the
hose sheathing. Tighten. Do not crush the wiring
harness (Figure 41).
Figure 41: Pull hoses straight and tighten
35. Attach the mounting bracket for the electric socket
on the front left bottom lip of the MH-400. The
mounting bracket should measure (from the center of
the bracket) 16.25 cm (6½ in) away from the left
front corner tube.
36. Use a 7 mm (9/32 in) drill bit to drill out holes for
mounting (Figure 42).
Figure 42: Attach mounting bracket for
electric socket
37. Attach the 4-prong socket using 9.375 mm (⅜ in)
bolts, washers, and nuts.