Setup Instructions

Page 20 Setup Instructions
How to Install the EH Control Pendant
on Tow Vehicle or Swing Arm
1. Remove the pendant and pendant bracket from the
packaging.
2. Attach the pendant bracket to the pendant. Remove
the two nuts and install the bracket, making sure the
tension knob is on the right side of the pendant
(Figure 48).
Figure 48: EH Control Pendant Mount
3. For Tow Vehicle mounting, determine an appropriate
location for the control pendant mount. Surface
should be flat and solid. For Swing Arm mounting,
install the pendant bracket into the end of the swing
arm.
4. Using the backing plate mark the four mounting
holes.
5. Drill four 8.7mm (11/32”) holes.
6. Attach the mount using the 7.9 x 38.1mm (5/16 x 1
½ in) bolts with the hardware provided (Figures 46
and 47).
Figure 49: EH Control Pendant Mount
Figure 50: EH Control Pendant Mount Backing Plate