Setup Instructions

Setup Instructions Page 27
7. Run the wire along the hydraulic hoses to the
7-prong electrical plug (Figure 63).
Figure 63: Run wire along hydraulic hoses to
7-prong plug
8. Cut the grey wiring harness, leaving enough wire to
connect to the 7-prong electrical plug. Repeat the
above steps for the left side brake assembly.
9. Use tie-straps to hold the wires along the hydraulic
hoses.
How to Wire the 7-Prong Harness
1. Strip off the ends of the two sets of wires—one from
the left brake assembly and one from the right.
2. Connect the black wires together and the white wires
together.
3. Install all the wires through the rubber protective
boot of the 7-prong plugs.
4. Install the rubber boot on the back of the electrical
plug (it protects the wires and keeps the connections
clean).
5. Attach the wires to the 7-prong plug (Figure 66).
6. Place the black wires into the blue port and the white
wires into the white port (black is for power and
white is for ground).
7. Cover all the joints with the white plastic spiral wire
wrap. This helps support the wiring connections.
I
MPORTANT: Solder all connections and bared wire
ends. Use heat shrink connectors on spliced joints.