Setup Instructions

Page 30 Setup Instructions
How to Install Tow Vehicle Brake
Components
Follow the instructions on Figures 62 and 65 to install the
brake controller on the tow vehicle.
Figure 61 shows a typical installation for the controller.
Note: For further information about brake controller and
load controller installation, refer to Warner Electric
document #P-1386 819-0129 and 819-0128.
Figure 64: Brake controller (example)
A. Mount the 7-prong plug and
bracket at the rear of the tow
vehicle
B. Mount the load controller in an
accessible location on the dash
or fender
C. Wire to fuse (15A for 4 brakes,
10A for 2 brakes, not provided)
and 12VDC
D. Clamp the foot controller to the
tow vehicle brake pedal,
following the manufacturer
instructions
E. Ground wire to tow vehicle
(Figure 63)
Figure 65: Install brake controller on tow vehicle