Setup Instructions

Setup Instructions Page 35
How to Install the Light Kit
1. Position the yellow marker light for the front side
underneath the safety decal (Figure 69). Measure
50 mm (2 in) in from the front corner tube of the
MH-400 and mark the top left hole.
2. Center punch and drill out the hole with a
5 mm (3/16 in) drill bit.
Figure 69: Position front side yellow marker light
3. Using the front side marker light as a template, mark
a second hole. Center punch and drill out the hole.
4. Ensure that the holes line up, then drill the last two
holes.
5. Drill two holes into the side of the hopper for the
wiring clamps, using a 5 mm (3/16 in) drill bit.
6. Drill one 11 mm (7/16 in) hole into the front corner
tube.
7. Attach the front marker light bracket to the MH-400
body using the four pop rivets supplied.
8. Remove the one hopper bolt and install the rear
taillight bracket, using a 7.8 x 37.5 mm
(5/16 x 1½ in) bolt (Figure 70).
Figure 70: Remove bolt for rear taillight bracket
9. Using the rear taillight bracket as a template, mark
the second hole and pre-drill it using a
7 mm (9/32 in) drill bit. Then drill it out using a
9mm (11/32 in) drill bit.
10. Install a bolt to the rear hole of the taillight bracket
using a 7.8 x 18.7 mm (5/16 x ¾ in) bolt, washer,
and nylon locking nut (Figure 71).
Figure 71: Install rear taillight bracket
11. Loosely attach the rear taillight to the bracket.
Ensure that the clear portion of the taillight faces
downward.
12. Drill three 7 mm (9/32 in) holes on the rear edge of
the side hopper wall (Figure 72).