Setup Instructions

Page 36 Setup Instructions
Figure 72: Drill holes on side hopper wall
13. Mark and drill ten evenly spaced holes with the
7 mm (9/32 in) drill bit along the upper lip of the
side hopper wall. Start 25 mm (1 in) away from the
front corner tube (Figure 76, left side view).
14. Repeat steps 1 through 13 on the opposite side of the
MH-400.
15. Drill six holes on the front bottom lip of the front
panel (Figure 73).
Figure 73: Drill holes on lip of front panel
16. Position the 7-prong socket into the connector
bracket on the front of the MH-400, 20 cm (8 in)
from the left side corner tube.
17. Drill two 9 mm (11/32 in) holes, and attach the
connector bracket with two 7.8 x 13.75 mm
(5/16 x ¾ in) bolts and nylon locking nuts
(Figure 74).
Figure 74: Attach connector bracket
18. On the left side, run the Item 4 wire (3.45 m [11.5 ft]
length) from the rear taillight along the underside of
the lip on the hopper side wall, and down to the front
marker light.
19. Secure the wiring with the rubber clamps and
7.8 x 13.75 mm (5/16 x ¾ in) bolts. Use nylon
locking nuts on the inside of the hopper wall lip. See
Figures 80 and 81 for wire lengths and routing.
20. Run the Item 6 wire (1.2 m [4 ft] length) through the
front tube and out the bottom (Figures 75 and 80).
Leave enough wire to connect the side marker light.
Figure 75: Wire front marker light
21. Place the number 6 grommet over the wiring and
into the hole drilled previously (into the tube).