Setup Instructions

Setup Instructions Page 37
22. Finish running the wiring to the trailer plug. Secure it
using the rubber clamps and 7.8 x 13.75 mm
(5/16 x ¾ in) bolts.
Note – Ensure that you apply spiral wrap wire protector
to any part of the wiring that may come into contact with
sharp metal edges (Figure 79, Detail B).
23. On the right side, run the Item 4 wire
(3.45 m [11.5 ft] length) from the rear taillight, along
the underside of the lip on the hopper side wall, and
down to the front marker light.
24. Secure the wiring using the rubber clamps and
7.8 x 13.75 mm (5/16 x ¾ in) bolts. Use nylon
locking nuts on the inside of the hopper wall lip
(Figure 76). See Figures 80 and 81 for wire lengths
and routing.
Figure 76: Wire rear taillight
25. Place the Item 5 wire (2.1 m [7 ft] length) through
the right front tube and out the bottom. Leave
enough wire to connect the side marker light
(Figure 77).
Figure 77: Wire side marker light
26. Place the number 6 grommet over the wiring and into
the hole drilled previously (into the tube).
27. Finish running the wiring to the trailer plug. Secure it
using the rubber clamps and 7.8 x 13.75 mm
(5/16 x ¾ in) bolts.
28. Note – Ensure that you apply spiral wrap wire
protector to any part of the wiring that may come
into contact with sharp metal edges (Figure 79,
Detail B).
29. Follow Figure 77 to connect all wiring to the lights
and the trailer plug on both sides.
Note – The ground wire for the rear taillights must be
connected to the taillight mounting bolts (Figure 78).
Figure 78: Connect ground wire to rear taillights
Note – Remember to apply heat to any shrink connectors
you install. Do not overheat the connectors.