Setup Instructions

Page 38 Setup Instructions
Note – When connecting the wiring to the rear of the
7-prong socket, ensure that you run the wiring through
the protective rubber sleeve before attaching the wires to
the socket.
30. Attach the tow vehicle and the 7-prong wiring socket
to the tow vehicle in a convenient mounting place.
31. Follow Figure 80 to connect the necessary wiring to
the 7-prong wiring socket from the tow vehicle.
32. Install the Item 11 reflective tape (15 cm [6 in]) to
the front and rear outer edges of the fenders on the
MH-400. Apply white tape on the front and red tape
on the rear (Figure 80, rear view and front view).
33. Ensure that all bolts, wire connections, and routing
are secure.
34. Test the wiring system to ensure proper installation.