Operator's Manual

currentworkingmemorysettingstoredinthe
handheldremote.
2.Pressthesamestartbuttonasecondtimeto
turnonthecomponentifthehydraulicsare
engaged(itshowsnumbersrampingupin
thedisplay).
3.Pressthesamestartbuttonathirdtime
tostorethenewsettingestablishedinthe
workingmemoryoftheremote.
•Afterpressingastartbuttononcetoviewthe
currentworkingmemorysettinginanon-working
mode,youhaveapproximately10secondsto
beginadjustingthesettingortheelementbefore
theremoterevertstooff.Inaworkingmode,the
10-secondruledoesnotapply.
•Toprogramapreset,youmusthavetheelements
activatedorengagedrst.
•Tooperatefromapreset,theyouseetheelement
speedpercentagesinthedisplaytoactivateor
engagethem.IfyouseethewordOFFinthe
display,youmustrecallthepreset.
ManuallyOverridingtheHydraulic
Controls
EHModels
Ifthehandheldremoteismissing,damaged,orfails,
youcanstilloperatethemachinetocompletetasksor
continueaspreadingjob.
PreparingtheMachine
1.Attherightsideofthemachine,removethe4
ange-headcapscrewsthatsecurethecover
platetotheoverridecover(Figure32).
g285427
Figure32
1.Rightsideofthemachine3.Coverplate
2.Overridecover
4.Flange-headcapscrew
2.Ensurethattheparkingbrakeisengaged,start
thetractionunit,andsupplyhydraulicpressure
tothemachine.
3.Locatethe3controlvalves(Figure33).
g285426
Figure33
1.Floor-speedsolenoid3.Attachment-speed
solenoid
2.Raise/lowerhopper
solenoid
Note:Refertothedecallocatedonthecover
plate(Figure34).
g285596
Figure34
1.Adjustoorspeed
4.Adjustspinnerspeed
2.Lowerthehopper
5.Coverplate
3.Raisethehopper6.Decal
32