Operator's Manual
UnloadingMaterial
WARNING
Themachineiscapableofamputatinghands
andfeet.
Keepyourhandsandfeetawayfromthe
conveyorandoptionalattachmentswhenthe
machineisoperatingandwhenthetraction
unitisrunning.
WARNING
Unloadingthemachinewhenitisnot
connectedtothetowvehiclemaycausethe
loadtoshiftandthemachinetotipover.
Ensurethatthemachineisconnectedtothe
towvehiclebeforeunloading.
•Donotstandbehindthemachinewhenunloading.
•Donotunloadthemachinewhileitisonaslope.
BulkUnloading
1.Backthemachineintothelocationwhereyou
wantthematerialdeposited.
2.Releasethereargatelatchesandturnonthe
conveyorbelt.
3.Ifdesired,raisetherearofthemachine.This
unloadsmaterialatadifferentangle,andallows
quickunloadingoftheentireload.
ControlledUnloading
1.Closethereargatelatches.
2.Usethejackhandletoopenorclosethe
adjustablesectionofthereargate(Figure
43andFigure44).Thisrestrictstheowof
materialswhenusinganoption.
Important:Usetheadjustablesectionof
thereargateonlywhenunloadingmaterial
smallerthan1inch(25mm)indiameter,
suchassandorgravel.
Important:Openthereargatecompletelyif
materialdoesnotowthroughtheadjustable
section.Testeachnewmaterialrst.
g014118
Figure43
1.Reargate2.Feedgatejack
g014119
Figure44
1.12.5cm(5inches)
maximumopening
2.Feedgate
OperatingtheOptional
Attachment
1.Shutofftheengineofthetractionunit.
2.OnSHmodels,usingthecontrollevers,turn
ontheoptionandtheconveyorbelt(unload
position).
3.ForboththeSHandEHmodels,adjustthe
settings,spreadpattern,andowrate.
40