Operator's Manual

Safety Instructions Page 9
WARNING: Do not carry passengers in the
hopper.
Unloading
Do not stand behind the MH-400 when unloading or
spreading. The twin spinner, cross conveyor and processor
eject particles and dust at a high speed.
WARNING: Do not unload the MH-400 or
disconnect it from the tow vehicle while
on a hill.
WARNING: Ensure that the MH-400 is
connected to the tow vehicle before
unloading.
CAUTION: Always remove options before
loading or unloading the MH-400 from a
trailer. Otherwise, the option may hit the
ramp or ground and be seriously
damaged.
Traveling
The MH-400 is designed only for off-road use. The
maximum recommended speed without a load is 24 km/h
(15 mph), and 13 km/h (8 mph) with a full load.
CAUTION: Before operating the MH-400,
raise the front jack and rear jack leg.
Remove the jack from the jack leg and
store it on the tongue during operation.
Maintain safe control of the MH-400. Do not attempt
abrupt maneuvers or other unsafe actions, especially on
hills or uneven ground.
CAUTION: Ensure that the cross conveyor
is centered. Traveling with it in the
extended position can damage the option
attachment brackets and swivel kit.
WARNING: Do not travel with the MH-
400 in the fully raised position. This
increases the risk of tipping over.
The MH-400 has a safe range for traveling with options
attached as shown by the green section in decal (see safety
decals on page 15).
CAUTION: Be aware that when traveling
with the processor option attached, that it
sticks out the right side of the MH-400
and the towing vehicle.
CAUTION: Do not travel with the MH-
400 in the caution range (yellow/black).
When no options attached, travel with the
machine in lowered position.
WARNING: Always slow down when
turning and avoid sharp turns. Otherwise,
the MH-400 may tip over.
Heavy loads and wet or uneven surfaces increase the time
it takes to stop, and reduce the ability to turn quickly and
safely.
CAUTION: Be aware of your surroundings
when turning or backing up. Ensure that
the area is clear and keep all bystanders at
a safe distance. Proceed slowly.
Turn off the option when approaching people, vehicles,
vehicle crossings, or pedestrian crossings.
The mirror mounted on the front of the hopper allows you
to monitor the load and the spreading action. Check the
mirror frequently to monitor the operation of the MH-400.
CAUTION: Do not operate the MH-400
with the weight case removed or out of
position. (see safety decals on page 12).