Operator's Manual

Page 42 Maintenance Instructions
Grease and Lubrication Schedule
Figure 33 shows the grease point locations.
• Use an automotive all-purpose grease.
• A spray or brush-on lubricant may be used on the
conveyer drive chain instead of grease.
• Lubricate regularly, after 25 hours of normal
operation.
• Lubricate daily when operating in extremely dusty
and dirty conditions.
• Clean grease fitting of foreign matter.
• Pump grease into all bearings and bushings.
• Clean off excess grease.
• Clean and repack wheel bearings every year or 300
hours.
I
MPORTANT: Do not over-grease, or the bearing seals
may be damaged. Two or three squirts per grease
point are usually enough, except when repacking the
wheel bearings.
Figure 33: Grease points
Grease Lubrication Schedule
Wheel bearings
Clean and repack every year
or 300 hours
Suspension bearings Once per year
Front take-up bearings Every 2 months or 25 hours
Rear drive bearings Every 2 months or 25 hours
Box hinge pins Every 2 months or 25 hours
Floor drive chain Every 2 months or 25 hours
I
MPORTANT: Do not over-grease, or the bearing seals
may be damaged. Two or three squirts per grease
point is usually enough, except when repacking the
wheel bearings.
WARNING: Replace all guards after
servicing.
Hydraulic Fluid System
The machines reservoir is filled with approximately 19
U.S. gallons (71.9l) of high quality hydraulic fluid. Check
the level of the hydraulic fluid before the engine is first
started and daily thereafter. The recommended
replacement fluid is: Toro Premium All Season Hydraulic
Fluid (Available in 5 gallon pails or 55 gallon drums. See
Parts Catalog or Toro distributor for part numbers.)
Alternate fluids: If the Toro fluid is not available, other
fluids may be used provided they meet all the following
material properties and industry specifications. We do not
recommend the use of synthetic fluid. Consult with your
lubricant distributor to identify a satisfactory product.
Note: Toro will not assume responsibility for damage
caused by improper substitutions, so use only products
from reputable manufacturers who will stand behind their
recommendation. High Viscosity Index/Low Pour Point
Anti-wear Hydraulic Fluid, ISO VG46.