Operator's Manual

g297178
Figure26
1.Floorspeed
3.Spinnerspeed
2.Raise/lowerhopper
•Toadjusttheoorspeed(Figure26),turntheknob
clockwise.Maximumoorspeedisusedinthe
Color-CodedOperatingSystemsothisadjustment
canbemadewhilenohydraulicowispresent.
Thisismostrelevantwhenyouhaveahopperfull
ofsand.
decal119-6832
Figure27
1.Adjustoorspeed
3.Raisethehopper
2.Lowerthehopper4.Adjustspinnerspeed
•Toraisethehopper(Figure26),pushinonthering
onthevalvestem.
•Tolowerthehopper(Figure26),pulloutonthe
ringonthevalvestem.
•Toadjustthespinnerspeed(Figure26),use
aat-headscrewdrivertoincreasebyturning
clockwiseordecreasebyturningcounter
clockwise.
Note:Ifadjustingwiththehydraulicowactive,
ensurethattheooristurnedoffifyoudonotwishto
havesandbeingspreadasyouadjust.
Onceyoursettingsareacceptable,usethehydraulic
owcontrolonyourtowvehicletoturnthesystem
onandoffforoperation.
KeyFunctionalityElements
•Whenthehandheldremoteisrstpoweredon,
thedisplayshouldreadFLROFFandOPTOFF
inapproximately5seconds.Ifthewords“waiting
forbase”areinthedisplay,checktoensurethere
iselectricalpowertothebaseunitandensurethe
E-STOPbuttononthebaseunitispulledout.
•Thereisalwaysacurrentworkingmemory.This
isnotthesameasapreset.Thelastsavedwork
settingswillbeinthecurrentworkingmemory
whenthehandheldremoteispoweredon.
•Operationalsequenceofthehandheldremote
startbuttons:
–Pressingastartbuttononce(ALLSTART,
FLOORSTART,orOPTIONSTART)callsupthe
currentworkingmemorysettingstoredinthe
handheldremote.
–Bypressingthesamestartbuttonasecond
timethecomponentturnsonifthehydraulics
areengaged(itshowsnumbersrampingupin
thedisplay).
–Pressingthesamestartbuttonathirdtime
willstorethenewsettingestablishedinthe
remote’sworkingmemory.
•Afterpressingastartbuttononcetoviewthe
currentworkingmemorysettinginanon-working
mode,thereisapproximately10secondstobegin
adjustingthesettingortheelementwillrevertback
tooff.Inaworkingmode,the10secondruleis
gone.
•Toprogramapreset,thekeytorememberisthe
elementsmustbeactivatedorengaged.
•Tooperatefromapreset,theelementspeed
percentagesmustbeinthedisplaytoactivateor
engagethem.IfthewordsOFFareinthedisplay,
thepresetmustberecalled.
ManuallyOverridingtheHydraulic
Controls
EHModels
Ifthehandheldremoteismissing,damaged,orfails,
youcanstilloperatethemachinetocompletetasksor
continueaspreadingjob.
PreparingtheMachine
1.Attherightsideofthemachine,removethe4
ange-headcapscrewsthatsecurethecover
platetotheoverridecover(Figure28).
24