Operator's Manual

KeyFunctionalityElements
•Whenthehandheldremoteisrstpoweredon,
thedisplayshouldreadFLROFFandOPTOFF
inapproximately5seconds.Ifthewords“waiting
forbase”areinthedisplay,checktoensurethere
iselectricalpowertothebaseunitandensurethe
E-STOPbuttononthebaseunitispulledout.
•Thereisalwaysacurrentworkingmemory.This
isnotthesameasapreset.Thelastsavedwork
settingswillbeinthecurrentworkingmemory
whenthehandheldremoteispoweredon.
•Operationalsequenceofthehandheldremote
startbuttons:
–Pressingastartbuttononce(ALLSTART,
FLOORSTART,orOPTIONSTART)callsupthe
currentworkingmemorysettingstoredinthe
handheldremote.
–Bypressingthesamestartbuttonasecond
timethecomponentturnsonifthehydraulics
areengaged(itshowsnumbersrampingupin
thedisplay).
–Pressingthesamestartbuttonathirdtime
willstorethenewsettingestablishedinthe
remote’sworkingmemory.
•Afterpressingastartbuttononcetoviewthe
currentworkingmemorysettinginanon-working
mode,thereisapproximately10secondstobegin
adjustingthesettingortheelementwillrevertback
tooff.Inaworkingmode,the10secondruleis
gone.
•Toprogramapreset,thekeytorememberisthe
elementsmustbeactivatedorengaged.
•Tooperatefromapreset,theelementspeed
percentagesmustbeinthedisplaytoactivateor
engagethem.IfthewordsOFFareinthedisplay,
thepresetmustberecalled.
ManuallyOverridingtheHydraulic
Controls
EHModels
Ifthehandheldremoteismissing,damaged,orfails,
youcanstilloperatethemachinetocompletetasksor
continueaspreadingjob.
PreparingtheMachine
1.Attherightsideofthemachine,removethe4
ange-headcapscrewsthatsecurethecover
platetotheoverridecover(Figure27).
g285427
Figure27
1.Rightsideofthemachine3.Coverplate
2.Overridecover
4.Flange-headcapscrew
2.Ensurethattheparkingbrakeisengaged,start
thetractionunit,andsupplyhydraulicpressure
tothemachine.
3.Locatethe3controlvalves(Figure28).
g285426
Figure28
1.Floor-speedsolenoid3.Attachment-speed
solenoid
2.Raise/lowerhopper
solenoid
Note:Refertothedecallocatedonthecover
plate(Figure29).
27