Operator's Manual

then,,or
ThescreenwilldisplayPRESETSAVED.
Note:IfyouholdtheSTOREbuttonandpressa
PRESETbuttonwhileeithertheoororoptionareoff,
nonewvalueisstoredforeitheroororoption;the
presetholdsthevaluespreviouslystored.
UsingaPresetMode
1.PressthedesiredPRESETbutton(1,2or3)to
displaytheoorandoptionsettings.
2.PresstheALLSTARTbuttontostarttheoorand
option(ifthehydraulicsareturnedon).
3.UsetheSTARTandSTOPbuttonstocontrolthe
oorandoptionasdesired
UnloadingMaterial
WARNING
Donotstandbehindthemachinewhile
unloading
BulkUnloading
1.Backthemachineintothelocationwhereyou
wantthematerialdeposited.
2.Releasethereargatelatchesandturnonthe
conveyorbelt.
3.Ifdesired,raisetherearofthemachine.This
unloadsmaterialatadifferentangle,andallows
quickunloadingoftheentireload.
ControlledUnloading
1.Closethereargatelatches.
2.Usethejackhandletoopenorclosethe
adjustablesectionofthereargate(Figure
39andFigure40).Thisrestrictstheowof
materialswhenusinganoption.
CAUTION
Usetheadjustablesectionoftherear
gateonlywhenunloadingmaterial
smallerthan1inch(25mm)indiameter,
suchassandorgravel.
CAUTION
Openthereargatecompletelyifmaterial
willnotowthroughtheadjustable
section.Testeachnewmaterialrst.
g014118
Figure39
1.Reargate2.Feedgatejack
g014119
Figure40
1.5inch(12.5cm)maximum
opening
2.Feedgate
35