Operator's Manual

Figure35
1.Hydrauliccontrols
3.Cylinder
2.Arrow
OperatetheTwinSpinner
1.Turnoffthetowvehicle
2.OnSHmodels,usingthecontrollevers,turnonthe
optionandtheconveyorbelt(unloadposition).
3.ForboththeSHandEHmodelsadjustthesettings,
spreadpattern,andowrate.
Note:Youmayhavetoexperimentuntilyouget
thedesiredowandspreaddepth.Othervariables
includegroundspeedandthetypeofmaterial.
Differentmaterialsvaryinparticlesize,whichcan
varythespreadpattern.
Alwaystestnewmaterialsbyspreadingtheminan
openareaawayfrompeople.
4.Startthetowvehicleandturnonthetowvehicle
hydraulics.
5.OntheSHmodelturnontheon/offpendant
switchtostartspreading.OntheEHmodelturnon
theoptionthentheconveyerbeltwiththewireless
controller.
6.OntheSHmodelturnofftheon/offpendant
switchtostopspreading.TheTwinSpinnerwill
continuetooperate.OntheEHmodelturnoffthe
conveyerbeltandthentheoption.
7.ForEHmodelsthe“allstart”functioncanbeused
inplaceoftheoptionstartandbeltstartfunctions
asasingleoperationstartfeature.Theoptionwill
startrst,thenfollowedbythebelt.
8.Whenthemachineisempty,turnoffthehydraulics
beforetransportingthemachine.
Note:Whendrivingoveruneventerrain,raise
themachinetothemaximumsafetravelingrange.
ThisprovidesmoregroundclearancefortheTwin
Spinner.
WARNING
Watchforpeopleandotherobjectswhile
spreading.TheTwinSpinnercanthrow
materialathighspeedsupto40feet(12m).
Important:Whiletravelingbutnotspreading,
raisethemachinetothemaximumsafe
travelingdistance,andturnofftheTwin
Spinner(
Figure35).
FineTuningtheTwinSpinner
1.Verifythatallthesettingsarecorrect.
2.Ifthespreadpatternisnottothedesired
consistency,loosenthehandlesandslidethehopper
inthedesireddirectiontoattainthedesiredspread
pattern.
Figure36
35