Form No. 3448-497 Rev A Installation Instructions QuickGroom 700 Model No. 46402AA—Serial No. 321000001 and Up Model No. 46402BA—Serial No. 321000001 and Up Register at www.Toro.com/bullseye.
WARNING Model No. CALIFORNIA Proposition 65 Warning Use of this product may cause exposure to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. Serial No. This manual identifies potential hazards and has safety messages identified by the safety-alert symbol (Figure 2), which signals a hazard that may cause serious injury or death if you do not follow the recommended precautions. Introduction g000502 Figure 2 1.
Safety General Safety This product is capable of causing personal injury. Always follow all safety instructions to avoid serious personal injury. • Read and understand the contents of both this Operator’s Manual and the operator’s manual of the traction unit before using this machine. Ensure that everyone using this product knows how to use this machine and the traction unit and understands the warnings. • Use your full attention while operating the machine.
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. 3 3 3 3 3 3 15 15 15 1 1 Connection plate Eyelet Spring washer Bolt (M10 x 20) Brush Mount plate Locknut Large washer Bolt (M10 x 50) Chain shackle Rope Assemble the brush. Assembling the Brush 1. 2. Install a mount plate on each brush. Install an eyelet to each of the 3 connection plates. g346861 Figure 3 1. Eyelet 3. Spring washer 2. Connection plate 4.
3. Connect the 3 brushes using the connection plates. 6. Use the rope to secure the attachment to the hitch on the traction unit. Ensure that the traction unit is not supporting the weight of the attachment (i.e., the attachment is not hanging from the rope). Note: If there is no hitch, refer to the Operator’s Manual of the traction unit to determine the preferred attachment point. g346862 Figure 5 1. Locknut—M10 (4) 3. Large washer (4) 2. Connection plate 4.
Product Overview Operation Specifications During Operation Safety Working width 1.85 m (72.83 inches) Weight 50 kg (110 lb) Minimum traction unit output-power rating 7.5 Kw (10 hp) General Safety • The owner/operator can prevent and is responsible • Attachments/Accessories A selection of Bullseye approved attachments and accessories may be available for use with the machine to enhance and expand its capabilities.
attachment while operating on slopes can cause the machine to become unstable. – Wait for all moving parts to stop before leaving the machine. • Do not operate the machine when there is the risk • Use extreme caution with other attachments. of lightning. These can change the stability of the machine and cause a loss of control. Always keep the machine in gear when going down slopes. Do not coast downhill (applicable only to gear-drive units).
Storage Storage Safety • Before adjusting, cleaning, storing, or repairing the machine, park the it on a level surface; engage the parking brake of the traction unit; shut off the engine; remove the key; and wait for all movement to stop before leaving the traction unit. • Store the machine on the storage stands positioned on a firm, level surface so that it does not sink or tip over. • Store the machine away from areas of human activity. • Do not allow children to play on or around the stored machine.
Notes:
Notes:
California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.
Warranty Statement One-Year Limited Warranty Conditions and Products Covered Parts Your Bullseye product (“Product”) is warranted to be free from defects in materials or workmanship for 1 year. Where a warrantable condition exists, we will repair the Product at no cost to you including diagnostics, labor, parts, and transportation. This warranty begins on the date the Product is delivered to the original retail purchaser.
