Installation Instructions

ManualsBrandsToro ManualsAttachmentsMagnet, QuickGroom 710

FormNo.3444-675RevB

Magnet

QuickGroom710

ModelNo.46408

InstallationInstructions

DANGER

Strongmagnetscanadverselyaffect

electronichealthdevices,suchas

pacemakersanddebrillators,wheninclose

proximityandcauseseriousinjuryordeath.

Consultahealthcareprofessionalbefore

usingthisproducttounderstandyourrisk.

CAUTION

Themagnetmaycollectsharporferrous

materials;contactwiththesematerialscould

causeinjury.

Donottouchtheturf-facingsideofthein-use

magnet.Useglovestocleanoradjustthe

magnet.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Clampbracket

Clampstrip

Mountingplate2

Spindle

Magnetbar1

Bolt(M12)

Bolt(M10)

Nut(M16)

Nut(M10)

Nut(M12)

Washer4

Installthemagnet.

PreparingtheMachine

NoPartsRequired

Procedure

1.Parkthetractionunitandattachmentonalevel

surface.

2.Engagethetractionunitparkingbrake.

3.Lowertheattachment.

4.Shutoffthetraction-unitengineandremovethe

key.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com/bullseye.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3444-675*

Summary of content (4 pages)

PAGE 1
Form No. 3444-675 Rev B Magnet QuickGroom 710 Model No. 46408 Installation Instructions DANGER CAUTION Strong magnets can adversely affect electronic health devices, such as pacemakers and defibrillators, when in close proximity and cause serious injury or death. Consult a healthcare professional before using this product to understand your risk. The magnet may collect sharp or ferrous materials; contact with these materials could cause injury. Do not touch the turf-facing side of the in-use magnet.
PAGE 2
. 2 Install 2 nuts (M16) onto the end of the spindle. Installing the Magnet Parts needed for this procedure: 2 Clamp bracket 2 Clamp strip 2 Mounting plate 2 Spindle 1 Magnet bar 4 Bolt (M12) 4 Bolt (M10) 10 Nut (M16) 4 Nut (M10) 4 Nut (M12) 4 Washer g348370 Figure 2 3. Secure the spindle to the clamp bracket. Procedure 1. Install the mounting plate 4 onto the groomer using 2 bolts (M10) and 2 nuts (M10).
PAGE 3
4. Loosely secure the clamp bracket and clamp strip to the magnetic bar using 2 bolts (M12), 2 washers, and 2 nuts (M12). 6. Ensure that the long part of the offset bracket is on the outside and insert the spindle into the mounting plate and secure it with a nut (M10). g348374 Figure 6 7. Repeat on the other side. 8. Adjust the spindle nuts on each side so that the magnet is the same height above the ground on both ends. 9. Tighten all fasteners. g348372 Figure 4 5.
PAGE 4