Installation Instructions

ManualsBrandsToro ManualsAttachmentsFieldMagnet 600

FormNo.3443-898RevB

FieldMagnet600

ModelNo.46411—SerialNo.321000001andUp

InstallationInstructions

Safety

CAUTION

Themagnetmaycollectsharporferrous

materials;contactwiththesematerialscould

causeinjury.

Donottouchtheturf-facingsideofthein-use

magnet.

DANGER

Strongmagnetscanadverselyaffect

electronichealthdevices,suchas

pacemakersanddebrillators,wheninclose

proximityandcauseseriousinjuryordeath.

Consultahealthcareprofessionalbefore

usingthisproducttounderstandyourrisk.

GeneralSafety

Thisproductiscapableofcausingpersonalinjury.

Alwaysfollowallsafetyinstructionstoavoidserious

personalinjury.

•Readandunderstandthecontentsofboththis

Operator’sManualandtheoperator’smanualof

thetractionunitbeforeusingthismachine.Ensure

thateveryoneusingthisproductknowshowtouse

thismachineandthetractionunitandunderstands

thewarnings.

•Useyourfullattentionwhileoperatingthe

machine.Donotengageinanyactivitythat

causesdistractions;otherwise,injuryorproperty

damagemayoccur.

•Donotputyourhandsorfeetnearmoving

componentsofthemachine.

•Donotoperatethemachinewithoutallguards

andothersafetyprotectivedevicesinplaceand

workingonthemachine.

•Keepthemachineawayfrombystanderswhileit

ismoving.

•Keepchildrenoutoftheoperatingarea.Never

allowchildrentooperatethemachine.

•Stopthemachine,shutofftheengine,engage

theparkingbrakeofthetractionunit,removethe

key,andwaitforallmovingpartstostopbefore

servicing,fueling,oruncloggingthemachine.

Improperlyusingormaintainingthismachinecan

resultininjury.Toreducethepotentialforinjury,

complywiththesesafetyinstructionsandalways

payattentiontothesafety-alertsymbol

,which

meansCaution,Warning,orDanger—personalsafety

instruction.Failuretocomplywiththeseinstructions

mayresultinpersonalinjuryordeath.

SafetyandInstructional

Decals

Safetydecalsandinstructionsare

easilyvisibletotheoperatorandare

locatednearanyareaofpotential

danger.Replaceanydecalthatis

damagedormissing.

decal105-0698

105-0698

1.Warning—readtheOperator’sManual.

decal133-8061

133-8061

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com/bullseye.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3443-898*

Summary of content (8 pages)

PAGE 1
Form No. 3443-898 Rev B FieldMagnet 600 Model No. 46411—Serial No. 321000001 and Up Installation Instructions Safety key, and wait for all moving parts to stop before servicing, fueling, or unclogging the machine. CAUTION The magnet may collect sharp or ferrous materials; contact with these materials could cause injury. Do not touch the turf-facing side of the in-use magnet.
PAGE 2
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Tow bar Tow bar support Bolt (3/8 x 2-1/2 inches) Washer (3/8 inch) Spring washer (3/8 inch) Nut (3/8 inch) Bolt (1/2 x 3 inches) Washer (1/2 inch) Spring washer (1/2 inch) Nut (1/2 inch) Bolt (1/2 x 1-1/2 inches) Wheel Set collar Serial decal 1 2 1 2 1 1 1 6 3 3 2 2 4 1 Assemble the magnet. Assembling the Magnet 1. 2. Install the tow bar supports to the tow bar.
PAGE 3
. 6. Loosely install the tow bar supports to the outer brackets on the magnet housing. Install the serial decal near the Prop 65 decal on the magnet housing. Note: Secure the supports on the inside of the brackets. g354010 Figure 5 1. Prop 65 decal 7. Secure the loop of the tow bar to a draw bar of a traction unit. 8. Adjust the height of the tow bar as needed so that the bottom of the magnet is parallel with the ground. 9. Torque the magnet housing bolts to 91 to 113 N∙m (67 to 83 ft-lb).
PAGE 4
Operation During Operation Safety • General Safety • • The owner/operator can prevent and is responsible • • • • • • • • • • • • • • • for accidents that may cause personal injury or property damage. Wear appropriate clothing, including eye protection; long pants; substantial, slip-resistant footwear; and hearing protection. Tie back long hair and do not wear loose clothing or loose jewelry. Use your full attention while operating the machine.
PAGE 5
attachment while operating on slopes can cause the machine to become unstable. • Use extreme caution with other attachments. These can change the stability of the machine and cause a loss of control. Always keep the machine in gear when going down slopes. Do not coast downhill (applicable only to gear-drive units). Operating Tips • Pick up metal materials by towing the attachment while driving forward.
PAGE 6
Notes:
PAGE 7
California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.
PAGE 8
Warranty Statement One-Year Limited Warranty Conditions and Products Covered Parts Your Bullseye product (“Product”) is warranted to be free from defects in materials or workmanship for 1 year. Where a warrantable condition exists, we will repair the Product at no cost to you including diagnostics, labor, parts, and transportation. This warranty begins on the date the Product is delivered to the original retail purchaser.