Form No. 3444-773 Rev B Wheel Kit RapidSeed 430 and 590 Model No. 46436 Model No. 46441 Installation Instructions Installation 1 Preparing the Machine No Parts Required Procedure 1. Park the traction unit and attachment on a level surface. 2. Engage the traction unit parking brake. 3. Lower the attachment. 4. Shut off the engine and remove the key. 5. If the attachment is connected to a traction unit, disconnect it; refer to the Operator's Manual for the attachment.
Installing the Wheel Kit No Parts Required Installing the Wheels Use bolts (M12), washers (M12), bushings, wheel shafts, and lock pins to secure the wheels to the wheel frame (Figure 1). g351062 Figure 1 1. Lock pin 5. Bolt (M12) 2. Bushing 6. Frame 3. Wheel 4. Washer (M12) 7.
Installing the Wheel Frame Refer to Figure 2 for this procedure. g356230 Figure 2 1. Hairpin cotter 11. Nylon bushing 6. Bolt (M16) 2. Cylinder 7. Cylinder bracket 12. Washer (M20) 3. Cylinder nipple 8. Locknut (M16) 13. Bolt (M20) 4. Copper washer (3/8 inch) 5. Link pin 9. Locknut (M20) 10. Wheel bushing 1. Use the bolts (M20), washers (M20), wheel bushings, nylon bushings, and locknuts (M20) to secure the wheel frame to the attachment side plates. 2.
Installing the Hydraulic Components Refer to Figure 3 for this procedure. g356231 Figure 3 1. Hydraulic hose 4. Male connector 2. Nipple 5. Clamp 3. O-ring 6. Cover plate 7.
1. Install the nipples, O-rings, and male connectors to the hydraulic hoses. 2. Route the hoses around the front of the attachment. 3. Use bolts (M8 x 50 and M8 x 55), cover plates, and clamps to secure the hoses to the side and rear of the attachment (Figure 3 and Figure 4). 4. Use a bolt (M8 x 55), cover plate, clamp, and nut (M8) to secure the hoses to the front of the attachment (Figure 4). g356233 Figure 4 1. Nut (M8) 4. Bolt (M8 x 55) 2. Clamp 5. Bolt (M8 x 55) 3.
Installing the Hitch g351202 Figure 5 1. Clevis pin 3. Hairpin cotter 2. Top link 4. Link handle 1. Install the link handle through the top link (Figure 5). 2. Use the lower hitch pins from the attachment to secure the hitch to the attachment. 3. Use the upper hitch pins from the attachment to secure the top link to the attachment. 4. Use a clevis pin and hairpin cotter to secure the top link to the hitch (Figure 5). Completing the Installation 1.
Notes: