Service Manual

SERVICE INSTRUCTIONS
H. Replace the wiring harness (fig.
5.41f).
I.
J.
Figure 5.41f
To save time later, the switch should
be tested
at this point. Refer to sec-
tion 2.8 for procedures.
To replace the trigger release, trigger
and spring, proceed
as follows:
a. Note that on the inside of the
trigger release there
is a small
hole. This hole accepts the short
end of the spring (fig. 5.419g).
Figure 5.41g
b. Lay
the left half of the battery
case on a work bench in a steady
position and install the trigger
release in position
(fig. 5.41h).
Figure 5.41 h
c. Insert the short end of the
spring into the hole in the
trigger release. The coil of
the spring must
fit over the
plastic boss in the case (fig.
5.41i).
Figure 5.41
i
d. Place the trigger over the long
end of the spring. Put the trig-
ger
boss into the hole in the
case. Carefully hold the trig-
ger in this position and
let go of
the spring and trigger release
(Fig. 5.41 j ) .
Figure 5.41
j
e. Place the remaining half of the
battery case over the trigger
mechanism, assuring the charg-
ing receptacle
is in place. Secure
the case halves
(fig. 5.41 k).
Figure 5.41
k
27