FORM NO. 3314228 OPERATOR’S MODEL NO. 51720 & UP MANUAL : k CORDLESS POWER™ STRING TRIMMER J To assure maximum safety, optimum performance, and to gain knowledge of the product, read and understand the contents of this manual before using the trimmer. Pay particular attention to the safety alert symbol which means CAUTION, WARNING OR DANGER — “personal safety instruction.” Read and understand the instruction because It has to do with safety. FAILURE TO COMPLY WITH INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
A\ SAFETY INSTRUCTIONS 17. Use only TOR charger and TOR PowerPack™ with your trimmer. 18. Keep all fasteners tight to be sure trimmer is in safe working condition. Folio maintenance instructions provided in this manual. 19. Do not operate your trimmer after it has been dropped or damaged. Return it to your nearest Authorized Toto Service Dealer for inspection and repair. 18. Maintain Appliance With Care—Keep cutting head and motor housing clean for best performance and to reduce the risk of injury.
ASSEMBLY INSTRUCTIONS CONNECTING TRIMMER TO POWER PACK (Fig. 1} 1. Insert trimmer plug into Toto PowerPack™ receptacle. Make sure the plug is all the way in the receptacle before beginning operation. RECEPTACLE Figure 1 CUTTING LINE (Figs. 2 & 3) NOTE: The cutting line for your trimmer is a special mono filament line, Your trimmer comes complete with a 12 foot supply of this line already wound onto the spool. 1.
OPERATING INSTRUCTIONS 4. It is possible under extremes use conditions to trip the circuit breaker in the PowerPack™. If this occurs, allow the tool to rest for a few minutes. Then reset the circuit breaker by pushing the button on the side of the Power Pack and continue. If the circuit breaker opens immediately, the system should be inspected by an Authorized Toto Electric Service Dealer. CIRCUIT BREAKER Figure 5 5.
OPERATING INSTRUCTIONS I Figure 7 Forward-backward cutting motion Figure 8 Sade-to-side cutting motion 8. Trim only when grass and weeds are dry. 7. The life of your cutting line is dependent upon following the previously stated trimming techniques, as well as what is being cut, and where the cutting is being done. For example, line will wear faster when trimming against a foundation wall as opposed to trimming around a tree.
OPERATING INSTRUCTIONS Note: To help prevent line tangle, tap once only to lengthen line. If additional fine is required, wait a few seconds before recapping trimmer shad. Do not allow line to wear too short, Keep ling length at 9” diameter as much as possible, 2. Lengthen the line only when line has been shortened by wear. Unnecessary lengthening will waste line. Note: The spool cap may wear during normal use of the line advance feature and may require occasional replacement.
OPERATING INSTRUCTIONS Note: Before reassembly, be sure to thoroughly clean out drum area and visually inspect for any damaged or worn parts. D. The stoop and the core are keyed. Be sure they are properly aligned when putting spool back on (Fig. 14). Thread end of line through eyelet, place spool on keyed Cora, and push in place until you hear it click (Figs. 14 & 15). Pyl line free from groove in spool. Unwind no mare than 3 inches from spool. 3.
PRODUCT IDENTIFICATION A mode! and serial number decal is located on the lower portion of the chrome tube. Always refer to specific numbers on this decal in correspondence or when replacement parts are needed. TOR SERVICE SUPPORT if help—concerning safety, set-up. operation, maintenance, or troubleshooting-is ever needed, contact the local Authorized Toto Electric Service Dealer or Distributor. Refer to tha “Yellow Pages” for assistance.