Operator's Manual

Setup

AssemblingtheBarandChain

DANGER

Contactwiththechainsawteethcancauseserious

injury.

•Removethebatterybeforeperformingany

adjustmentsormaintenancetothechainsaw.

•Alwaysweargloveswhenperformingany

adjustmentsofmaintenancetothechainsaw.

Ifthebarandchainarenotalreadyinstalled,performthefollowing

steps:

1.Placethechainsawonalevelsurface.

2.Removethetwoboltsthatsecurethecover(Figure1).

Figure1

1.Cover

2.Nuts

3.Turnthechaintensioningbolttothelefttomovethe

mountingplateclosetothesprocket(Figure2).

Figure2

1.Sprocket3.Stud(2)

2.Tensioningbolt4.Adjustingpin

4.Alignthebarwiththetwostudsandtheadjustingpin.

5.Placethechainaroundthedrivesprocket,withtheteethof

thechainfacingawayfromthesprocket(Figure2).

6.Feedthechainintothegrooveinthebar.

7.Installthecoverandthenuts,butdonotfullytightenthe

nuts.

8.Holdupthetipofthebar(Figure3).

Figure3

9.Tightenthechainbyturningthetensioningbolttotheright

(Figure2),untilthechaintouchestheundersideofthebar.

10.Tigthenthe2nuts(Figure1).

11.Checkthechaintension.Ifmoretensioningisrequired,

repeatthisprocedurestartingat7.

Note:Thechaintensioniscorrectwhenyouareable

touseaglovedhandtopullthechainsmoothlyaround

thebladebar

Note:Anewchainmayneedadjustingafterit’srst

use.RefertoAdjustingtheChainTension(page14).