Operator's Manual
21
Maintenance
Storing the Product
6WRULQJWKHSURGXFWGL൵HUVGHSHQGLQJRQWKHDPRXQWRIWLPH
LWZLOOEHLQVWRUDJH
Note: If the product includes another attachment, place the
storage cap on the end of the attachment shaft and hang it up
to store.
To Store the Product Short Term:
Follow these steps to store the product short term.
1. Clean all foreign material from the product.
2. Store the product in a well-ventilated place that is inac-
FHVVLEOHWRFKLOGUHQ
To Store the Product Long Term:
If you do not intend to use the product for more than one
PRQWKIROORZWKHVWRUDJHSURFHGXUHVEHORZ
Follow these steps to store the product long term.
1. Drain all of the fuel from the tank into a container ap-
proved for gasoline.
Note:$ELGHE\DOOIHGHUDODQGORFDOUHJXODWLRQVIRUWKH
safe storage and handling of gasoline.
2. Run the engine until it stops.
3. Clean all foreign material from the product.
4. Store the product in a well-ventilated place that is inac-
FHVVLEOHWRFKLOGUHQ
Note: Keep the product away from corrosive agents
such as garden chemicals and de-icing salts.
Transporting the Product
Follow these steps to transport the product.
1. Drain the fuel mixture into a container that is approved
for use with gasoline.
2. &DUU\WKHSURGXFWE\WKHIURQWKDQGOH
3. Secure the product in your vehicle or on a trailer.
5. Hand thread the new spark plug, turning it clockwise.
6. 7LJKWHQZLWKDVRFNHW>WRUTXHWRLQOE1P
PLQLPXPLQOE1PPD[LPXPDo not
over-tighten@.
NOTICE:
Be careful not to cross-thread the spark plug.
Cross-threading will seriously damage the
product.
Idle Speed Adjustment
See Figure 19.
WARNING:
The cutting head will move when adjusting the
idle speed. Wear all protective clothing and keep
DOOE\VWDQGHUVFKLOGUHQDQGSHWVDWOHDVWIW
PDZD\0DNHDGMXVWPHQWVZLWKWKHXQLW
VXSSRUWHGE\KDQGVRWKDWWKHFXWWLQJKHDGGRHV
QRWFRQWDFWWKHJURXQGRUDQ\REMHFW.HHSDOO
SDUWVRI\RXUERG\DZD\IURPWKHFXWWLQJKHDG
DQGPX൷HU)DLOXUHWRIROORZWKHVHLQVWUXFWLRQV
could result in serious personal injury.
If the cutting attachment turns at idle, the idle speed screw
needs adjusting on the engine. Turn the idle speed screw
counterclockwise to reduce the idle RPM and stop the cut-
ting attachment movement. If the cutting attachment still
PRYHVDWLGOHVSHHGFRQWDFWDTXDOL¿HGVHUYLFHGHDOHUIRU
adjustment and discontinue use until the repair is made.
WARNING:
The cutting attachment should never turn at idle.
Turn the idle speed screw counterclockwise
to reduce the idle RPM and stop the cutting
attachment, or contact a service dealer for
adjustment and discontinue use until the repair
is made. Serious personal injury could result
from the cutting attachment turning at idle.
Figure 19
Idle Speed
Screw