Installation Instructions

Connecting Cables
Connect cables with cable connectors supplied with your kit.
Place the cable from the fixtures in the groove marked “18 GA.”
and the power pack in the groove marked “16 GA.” Now put the
cover over the cables and fasten with a screw.
Wood Accent Light can also be used without the top.
Position the cable in the channel on the backplate and place it in
the corner. Fasten the backplate and reflector to the rail using
5
/8-inch screws. The cable must be fastened securely to prevent
the contacts from damage.
Routing Cable
The lens has break-off tabs on both sides. If you are running the
cable out the side, you must remove a tab. Using pliers, grip the
tab and bend it outward. It will break off and you can snap the
lens on.
Versatile Applications
Note:
If the lens snaps off
too easily, loosen the
mounting screws.
Landscape
Timber
Deck
Rail
Rail
Deck
Post
Wall
Ceiling
Rail
Rail
Step
Step
On landscape timber
Up lighting for
plants
On the rail of a deck
Mounted to a post or
wall
Under the rail of a
deck
Without wood under
a rail
Without wood under
a step
Offset for backlighting
under a rail or deck
Under a rail or step
for safety
Indirect lighting
Up lighting for
plants