Operator's Manual

8
TORO
1. Press on the light bulb cap (Fig. 27).
2. Install the light bulb into the fixture
(Fig. 28).
3. Loop the cable around the stake (Fig. 29).
Loop the cable around the channels in the
stake. Make sure the cable is centered around
the stake head and is tight. If the cable is loose,
pull the ends to eliminate slack.
4. Secure the fixture head to the stake.
Press the stake firmly into the fixture (Fig. 30)
Insert the bolt through the fixture head and stake
(Fig. 31).
Screw the fastener knob onto the bolt and turn
until the bolt stake and fixture head are securely
in place (Fig. 31).
6. Put the stake into the ground (Fig 32).
7. Adjust the light beam (Fig. 33).
To adjust the light beam from narrow to broad,
turn the focus ring.
To adjust the light pattern from vertical to
horizontal, turn the lens using the lens tabs.
2
3
1
Premium Varifocus
©
Floodlights
Fig. 27 Fig. 28 Fig. 29 Fig. 30
Fig. 31 Fig. 32 Fig. 33