Operator's Manual

9
Premium Colonial Pathway Light Fixture
1. Install the light bulb (Fig 34).
2. Firmly center the cable straight over the
piercing points (Fig. 35).
3. Attach the stake to the fixture (Fig. 36).
Slide the closed stake onto the fixture base.
(Follow the arrow direction on the fixture.) This
locks the cable against the contacts.
4. Run the cable inside the stake.
Open the stake by pinching together the locking
tabs near the base of the stake (Fig. 37).
Fold the cable into each side of the stake. Align
the cable with the notches at the bottom of the
stake and snap the stake closed.
Snap on the black cover by pushing it straight
down onto the lens.
5. Put the stake into the ground (Fig. 38).
Fig. 34 Fig. 35 Fig. 36 Fig. 37 Fig. 38
Premium Contemporary Pathway Light Fixture
1. Install the light bulb (Fig. 39).
2. Firmly center the cable straight over the
piercing points (Fig. 40).
3. Attach the stake to the fixture (Fig. 41).
Slide the closed stake onto the fixture base.
(Follow the arrow direction on the fixture.) This
locks the cable against the contacts.
After the stake is attached, attach the black cover
to the top of the fixture. Rotate the cover until the
locking tabs on the lens snap into place on the
cover.
4. Run the cable inside the stake (Fig 42).
Open the stake by pinching the locking tabs
together.
Fold the cable into each side of the stake. Align
the cable with the notches at the bottom of the
stake and snap the stake closed.
Snap on the black cover by pushing it straight
down onto the lens.
5. Put the stake into the ground (Fig. 43).
Fig. 39 Fig. 40 Fig. 41 Fig. 42 Fig. 43