FORM NO. 3319-374 MODEL 52501 | another SOLAR PATH LIGHT OPERATOR'S MANUAL PLEASE READ THIS GUIDE COMPLETELY BEFORE USING THIS PRODUCT.
10 N The SOLAR PATH LIGHT is a Solar-Powered garden and pathway light. Otis weather-proof, and intended to operate in divest sun light. Please locate your SOLAR PATH LIGHT in a position where the Solar Panel will collect maximum sun light as it will greatly improve its performance. The SOLAR PATH LIGHT contains a rechargeable Nickel-Cadmium (Ni Cd) battery. This rechargeable battery is shipped without charge.
Caution: Do not press down on the Top Lens as it may destroy the Solar Panel. LY Contact with buried utility lines could result in death or serious injury. Before digging any hole or placing stake in ground, contact your utility companies to male sure that there are NO buried lines! €} PERFORMANCE During the day, the Solar Panel converts sunlight into electricity and recharges the hatter. At night, the light turns on automatically using the electricity stored during that day.
E) OPERATION 1) INITIAL CHARGE: Place the SOLAR PATH LIGHT in full sun for two days to charge the battery before first use. Please move the Power Switch to the OFF position during this charge period. You may use the optional AC adapter {TOR MODEL 52504) to charge the battery for 24 to 36 hours (maximum} fo ensure that it has a full charge prior to normal operation. The charge adapter is designed for INDOOR USE ONLY. Bring the SOLAR PATH LIGHT indoors when charging with the adapter.
1f your SOLAR PATH LIGHT does not function properly, make sure that you have read the above operation instructions, then take the following steps: 1. Examine the SOLAR PATH LIGHT to make sure that the solar panel is not broken. 2. Move the switch back and forth between "AUTO" and "OFF” a few times. 3. Make sure that the light sensor (Solar Panel} is located such that no other Tight is shining on it after dark.
23 To replace the battery, remove the sig screws from the cover. You can see the battery inside. Take the battery out and disconnect the 2 battery wire leads gently. Remove and replace the battery (use 6V/ B00mAR 'AA' Ni-Cd battery). Attach the 2 wire leads to the battery contacts, Red to Black to Put the battery back into place. Fig. 5 3)To replace fluorescent lamp, slide the Power Switch to the "OFF” position, Rotate the fluorescent lamp 90 degrees, then take it out. Replace with a new fluorescent lamp.
The Toto Promise A Full Warranty The Toto Company warrants this TOR Product against defects in material or workmanship. The following time periods apply from date of purchase.