Installation Guide

Press NEXT to set PROGRAM ERASE function OR Press DIAL to move to AUTO-RUN
PROGRAM ERASE – You can erase all program information for a selected
program. This can be done for any selected program.
Press NEXT to select the program to erase.
Press +/ON to erase. will flash 5 times.
Dial position: AUTO-RUN
The AUTO-RUN position is used to provide information regarding the controller's
operation as well as for reviewing all data stored in the irrigation programs.
The following is a list of information you can observe on the display:
• Current Time & Day
• Program(s) in OFF position
• Information regarding the operating station: program, station and start times
• Active Rain Delay
• If irrigation is suspended due to SENSOR input
• Circuit breaker cut off the operation of a station(s)
• Power failure indication
To turn OFF the working cycle, press DIAL to MANUAL PROGRAM and
Status: If you wish to have a complete status report on the operating station:
Press NEXT to STATUS.
Remaining station RUN TIME will be displayed as well as the operating program.
Press NEXT to return to AUTO-RUN position.
Note: During programming, the dial will return to the AUTO-RUN position
automatically after 3 minutes of inactivity.
-10-
press -/OFF.
Program Review: If you wish to review what data you have in each program:
Press NEXT to PROGRAM REVIEW. Press PROG to select the program.
Press +/ON to start the review.