TOR OWNER'S OPERATING AND PARTS MANUAL iy 5 e 5HP LAWN TRACTOR MODEL NOS. 57100 (MANUAL START) AND 57200 (ELECTRIC START) (INCLUDES SERIAL NOS.
FOREWORD The riding rotary lawn mower is precision machine which will require a minimum of care. Keep it clean and well lubricated. Keep the blade sharp and balanced. Use it within its capabilities. I kept in good repair and adjustment, iris capable of providing years of dependable service. DEALER RESPONSIBILITY Before the mower is delivered to the customer, the dealer should prepare it for operation and should be sure that the owner understands the instructions for aerating and caring for his tractor.
THINK OF SAFETY BEFORE YOU MOW 1. Never allow children or young teen-ages {o operate the tractor. Keep children and pets away from the area of the mower at all times while it is working 2. Always keep hands and feet out from under the mower deck while the engine is running, and until you are SURE that the blade has sipped furring after the engine is shut off or the blade clutch disengaged. I will coast for several seconds. 3.
PUT YOUR MOWER TO WORK CHOOSE THE RIGHT CUTTING HEIGHT In general, use the same cutting height you have used before. You know what height is best for your own lawn. 2. When first using your mower, cut the grass a little longer than you did before, until you're sure that the greater cutting width will not cause scalping due to irregularities in the lawn. 3.
HOW TO KEEP YOUR TRACTOR WORKING FOR YOU CAUTION Always remove the battery from electric start tractors, to avoid spillage of the electrolyte, before servicing the unit. Replace battery before attempting to operate the engine. Do not over-filo battery, engine or transmission, The simple service required for your mower will result in longer life and dependable operation. LUBRICATION 1.
LUBRICATION CHART LUBRICATION POINT LUBRICANT TO USE HOW OFTEN o»op W Transmission Gearshift Ball Blade Clutch Lever Pivot Blade Clutch Idler Pulley Bearing Front Frame Pivot Kingpin Bearings Steering l Linkage Pivot Points Front Wheel Bearings Pivots of Clutch and Brake Pedal Linkage Traitor Drive Belt Idler Arm Pivots Tractor Drive Belt Idler Pulley Bearing Blade Clutch Handle Pivots Steering Column Bearing Blade Height Adjustment (Not Illustrated) Blade Sp indie Bearings (Not Illustrated) Engine Crankcas
22 FRONT END AND WHEELS Ref. Ref. No, | Part No. Description Qty. No. | Part No. Description Qy. WHEEL GROUP 1 7-0300 Handle Wheel Says 2 2 | Handle Grip. 2 {Consists of) 3 322-6 Bolt.. . 2 a. 1 4 | Nut. 2 b. Valve Cora | 1 5 7-0123 Bolt. 1 242 .38 c. 1 8 3256-8 Washer . 1 21 Wheel Says Front 2 7 32136-3 Nut Castellated 1 (Consists of) 8 3272-7 Pin Cotter. 1 a. Bearing 2 i 7-0124 Ball Joint Says 1 302-8 b. Grease Fitting 1 10 3218-3 Nat, 7-0131 Washer. . 4 11 3263-21 Lock washer. 2 23 | a212-11 Cotter Pin.
HOOD AND FENDER Ref Ref | No. | Part No. Description Qty No. | Part No. Description Qty 1 7-0220 Hood front. 7-0301 Grommet 1 2 7-0226 Hood rear. 1 20 | | Shut off valve.. 1 . 3 32122-42 (s} | Truss Screw 4 21 | 7-0818 1 4 3217-5 4 22 | 7-0214 Gas Gauge . 1 5 9-0221 Hood Grille. 1 23 | 7-0215 Fender Rear 1 8 7-0222 Tie Rod 1 24 | 323-4 Bolt 2 7 3272-7 Cotter Key. 2 25 | | Nut.. 2 8 3254-8 Washer, Shake proof. 4 26 | 2412.
Ref. Part No. | Description Qty. No.| Part No. | Description Qy. CHASSIS GROUP 74 | 351-1 1 75 | 3283-1 Bolt Carriage . 1 1| 7021 Chassis 1 76 | 3258-7 Lock washer Spring 7-0810 Chassis Says Electric 8218-5 1 4 | | Bearing Steering 2 78 | 7-0161 1 4 | 7-0125 Column. 1 79 | 7-0162 1 5 | 7-0126 Wash: 1 80 | 233-18 1 6 | 3212072 Snap Ring. 1 81 | 7.0163 1 7| 70127 Arm Latch 1 82 | 7-0164 1 & | 7-0128 Pedal 1 83 | 32152-is) 1 9 | 7-0130 Washer.
TRANSMISSION ASSEMBLY Ref. Ref] No.| Part No. Description Q. No.| Part No. Description Q. 1| |Lever & Housing Says, 33 | 219202 Gear, Shifting 1 Shift (Incl. Nos. 3 1 34 | Gear, Spur e tooth) 1 2 | 2116-229 Ring, Snap [Span 1 3 | 23718 Ring, Quad 1 36 | forbear. Soar @ doth 1 4 | 321316 Pin, Roll 1 37 | 1 5 | Housing, Shift lever i 38 | Gear, Spur (16 teeth} 1 6 | 2119.228 Keeper, Shift lever 1 38 | Shalt, Tut 1 7 | Lever, Shift Rt 40 | 2119-208 Spur Gear, ot shalt. 1 8 | |Rod Says, Shift (incl. Nos.
25-Inch Mower Attachment Ref. #18 not illustrated Ref. Ref. Neo. | Part No. Description Qty. No. | Part No. Description Qy. 1 7-0246 Hsg. Weld Says 1 24 | 2 2 7-0247 Bret. Says R.H 1 25 7-0263 Bret. Mower Hsg. 7-0248 Bret. Says L.H 1 26 102684 Bret. Mower Mtg. 7-0250 Alt. 107 27 7-0265 Bell Crank 4 5 Nut... 10 28 7-0266 Shaft Front Pivot. 1 6 7-0251 Spindle & Hsg. Says. 1 29 | 7-0267 Shaft Rear Pivot 1 {Consists of} 30 | |Roll Pin 4 . 7-0287 a. Hsg. Spindle. 7-0268 Link Lift . 2 251-5 b.
REMOVAL AND REPLACEMENT OF PARTS CAUTION Before servicing any part of the mower or tractor, disconnect the spark plug wire o prevent accidental starting of the engine. Remove hatter from electric start tractors. T332 25-Inch Blade Block up the tractor 6 inches at the rear end. Disengage the blade clutch, so that the blade brake keeps the spindle from turning, Remove the blade by removing the spindle nut, which has aright-hand thread.
Mower Drive Belt Remove the tractor drive belts described above, for access to the mower drive belt, then remove the 5/16 inch bolt which holds the blade clutch idler arm to the tractor chassis. Wring the mower drive belt over the mower drive pulley and remove from the engine pulley. Replace the belt first on the engine pulley, then wring it note the mower drive adapter pulley. Replace the linkage and springs which were disconnected. Replace the tractor drive belt as described above.
Operation and Maintenance of the Electric Starter Iris necessary to follow these additional instructions if your lawn mower is equipped with electric starting. Following these instructions will assure you of the best continued benefits of electric starting. PREPARING FOR OPERATION The “dry-charged” battery and its container of electrolyte are shipped in separate carton inside the mower carton. Your dealer should have activated, connected and installed the battery.
4. Keep the battery clean by brushing off dirt dust and grass clippings after use. K corrosion develops on top of the battery, clean it with water and baking soda. Storekeeper the vent plugs in the cells while cleaning, Coat the cleaned terminals with petroleum jelly (Vaseline) to prevent further corrosion. §. Batteries maybe stored without damage if they are fully charged when placed in storage. Originator dry place, where the temperature is between 320 F and 80° F.
RO PRODUCT CHANGES In an effort to make improvements available to Toto owners as quickly as possible, minor changes are incorporated into Toto's products from time o time that do not become immediately shown in the Reference Drawing and Parts List, I such a change apparently has been made in your unit, which is not reflected in your manual, see your Torah distribute or his authorized Toto service dealer for information and parts bummers.
SAFETY TIPS FOR RIDING LAWN MOWERS, GARDEN TRACTORS AND ATTACHMENTS Improper use of riding lawn mowers, garden tractors and attachments on the part of the operator can result in injury. To reduce this possibility, give complete and undivided attention to the job ot hand. 1. Know the controls and how to stop quickly — READ THE OWNER'S MANUAL. 2. Do not allow children to operate machine; nor dulls to operate it with. out proper instruction. 3. Clear work area of objects which might be picked up and thrown. 4.