Service Manual

Model 200/210

1. Remove the screw securing the carburetor

mount/reed plate to the crankcase.

2. Remove the carburetor mount/reed plate and

carburetor mount/reed plate gasket.

Fuel Tank And Lines Disassembly, Inspection,

And Reassembly

Fuel Tank And Cap

1. Inspect the fuel tank for cracks, rubbing, or

chaffed spots. Replace the tank if necessary.

2. Inspect the rubber fuel tank mounting pads

(on either side of the tank) for condition. Re-

place the mounts if necessary.

3. Inspect the fuel tank cap for cracks, damaged

vent valve, or other visible signs of damage.

Replace the cap if necessary.

Fuel Line And Filter Removal

Units equipped with a primer have two fuel lines to

the fuel tank. The clear line provides normal fuel

flow. The blue line provides a return line for excess

fuel flow during primer operation. The blue (primer)

line is removed/installed in the same manner as the

fuel line except it does not have a fuel filter.

To remove the fuel lines and fuel filter:

1. Slide the retainer off of the fuel line/fitting.

2. Push the fuel fitting, fuel filter, and fuel line out

of the fuel tank through the tank neck.

3. If fuel the filter is dirty or clogged, replace it

with new fuel line assembly.

DISASSEMBLE MAJOR

COMPONENTS (cont.)

2.6089.048

2.6277.140

2.6081.047

DISASSEMBLY, INSPECTION, & REPAIR

3-23