Service Manual

Model 200/210 Blowers

1. Remove the screw(s) securing the reed valve

components to the carburetor mount/reed

plate.

2. Remove the reed backup, reed, reed valve

seat, and valve seat gasket.

Reed And Reed Backup Installation

NOTE: Pay attention to the shape of the carbu-

retor mount/reed plate surface the reed and

reed backup are mounted on.

All blowers and blower/vacs, and older trimmers and

cultivators have a “flat” reed mounting surface. The

reed valve for these units have a slight downward

curve.

Newer trimmers and cultivators have a reed mount-

ing surface that is curved upward. The reed valve

for these units is flat.

If unit has flat reed plate, make sure a gap of 0.105-

0.110 (2.7-2.8 mm) is maintained between the carbu-

retor mount/reed plate and reed backup plate.

DISASSEMBLE MAJOR

COMPONENTS (cont.)

3.6090.137

2.6089.052

3.6089.053

Correct

Incorrect

DISASSEMBLY, INSPECTION, & REPAIR

3-25