Service Manual

Push Button Switch

1. Remove the screw and washer securing the

switch into the styling cover.

2. Pull the switch out of the styling cover from the

back. The push button cap will come off of the

switch as it is removed.

3. Reassemble the switch in the reverse order of

disassembly.

Starter Disassembly, Repair, And Reassembly

WARNING: Spring under tension!

The rope starter on these engines contains a flat wire

spring that is under tension. eye and hand

protection when replacing worn or broken spring, in

case it should uncoil as it is handled. Allow spring

tension to be completely relieved and make sure

pulley disengages from spring before removing the

pulley retainer(s), pulley, and starter spring from

housing.

Adding Starter Spring Tension

If the rope pull handle does not fully return against

the starter housing, the spring may need another turn

of tension. Additional tension can be added without

disassembling the starter.

To add spring tension:

1. Pull the rope out a short distance and hold the

pulley from turning.

2. Wind one or more extra turns of rope onto the

pulley.

DISASSEMBLE MAJOR

COMPONENTS (cont.)

2.6089.072

3.6089.071

2.6060.153

DISASSEMBLY, INSPECTION, & REPAIR

3-34