Service Manual

Inspection And Service
1. Inspect the starter rope for wear or frays. Re-
place the rope if necessary.
2. Inspect the starter pulley for worn pawl en-
gagement teeth. Also check for wear on the
surface of pulley that is in contact with the
starter spring.
3. Make sure old grease and dirt are cleaned
from all starter components before reassem-
bling.
Starter Reassembly
1. Install the starter spring into the starter
housing as follows:
a. Orient the replacement starter spring so the
spring windings are clockwise (the open end
of spring hook is to the left).
b. Grasp the spring near the spring hook with a
needle-nose pliers and carefully remove the
spring retainer.
DISASSEMBLE MAJOR
COMPONENTS (cont.)
2.6089.078
2.6047.092
2.6089.077
3
DISASSEMBLY, INSPECTION, & REPAIR
3-37