Service Manual

7. Install the pulley/rope assembly into the starter

housing. Rotate the pulley slightly until the

spring hooks onto the pulley and the pulley

drops into place.

8. Route rope through the guide bushing in the

starter housing. If so equipped, install the

additional rope guide bushing over the rope.

Install the pull handle on the rope and secure it

with a single knot.

9. Install the pulley retainer(s) and screw(s).

Torque the screws to 20-30 in•lb (2.3-3.4

N•m).

10. Pull the rope out to its full length and let it re-

turn. Check the spring tension and adjust as

necessary. Refer to “Adding Starter Spring

Tension” above.

Remove Ignition Module

1. Make sure the spark plug wire, and the lead

wires to the ignition module are discon-

nected.

2. Remove the screws securing the ignition

module to the cylinder. Remove the ignition

module and, if so equipped, the push-to-

stop switch wire.

Remove Flywheel

WARNING: Cracked or Broken Cooling Fins

Are A Hazard!

Be careful not to crack or break any cooling fins.

They could fly off during operation. If cooling fins are

cracked or broken, replace the flywheel.

DISASSEMBLE MAJOR

COMPONENTS (cont.)

2.6089.082

2.6089.074

2.6089.081

DISASSEMBLY, INSPECTION, & REPAIR

3-39